Before First Use - SOLIS SLICE & MORE FB-333A Mode D'emploi

BEFORE FIRST USE

s
Before using your multigrater for the first time, remove all potential stickers and
●
labels (apart from the type plate).
Disassemble the appliance as described in the chapter "Disassembling the
●
Multi grater" (see page 63).
Rinse all parts of the multigrater apart from the motor unit with warm water
●
(not above 50 °C) and some detergent. Make sure not to hurt yourself on the
GB
sharp grating blades in the cutting drums. Best use a dishwashing brush for the
cutting drums. Dry all parts carefully.
Wipe the motor unit clean with a soft, slightly moist towel.
●
When all parts are completely dry, reassemble the multigrater as described in
●
the chapter "Assembling the Multigrater".
A SS E M B LI N G T H E M U L TI GR AT E R
s
ST EP 1:
Place the motor unit on a smooth, dry, stable, moisture resistant and even work
●
surface, near a power outlet.
60
ST EP 2:
Choose a suitable cutting drum. Push the cutting drum into the holder from
●
behind, until it touches the front end of the holder.
ST EP 3:
a) Place the cutting drum holder in the motor unit, the funnel has to positioned
●
at 1 o'clock.
b) Then, turn the funnel in a counter clockwise direction (towards "Lock") into
the 12 o'clock position, so that it audibly locks into place.
a)
GB
b)
61