Turning The Burner Off; Automatic Switch-Off; The Heat Setting; Automatic Heat Up - AEG HD634170NB Notice D'utilisation

10 www.aeg.com
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
nute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.

4.2 Turning the burner off

To put the flame out, turn the knob to
the symbol
WARNING!
Always turn the flame down or
switch it off before you remove
the pans from the burner.
OPERATING THE INDUCTION ZONES
Touch
the appliance.
After use, switch off the hob element by
its control and do not rely on the pan
detector.
4.3 Automatic Switch Off
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, the cook-
ing zone must be cool.
• You use incorrect cookware. The sym-
bol
zone deactivates automatically after 2
minutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
.
for 1 second to start or stop
comes on and the cooking
comes on and the appliance
• The relation between heat setting and
times of the Automatic Switch Off
function:
•
, - — 6 hours
•
- — 5 hours
•
— 4 hours
•
- — 1.5 hours

4.4 The heat setting

Touch to increase the heat setting.
Touch to decrease the heat setting.
The display shows the heat setting.
Touch and at the same time to
switch off the cooking zone.

4.5 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automat-
ic Heat Up function. This function sets
the highest heat setting for some time
(see the diagram), and then decreases to
the necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch . The symbol
in the display.
2. Immediately touch
comes on in the display.
3. Immediately touch
again until the necessary heat set-
ting comes on. After 3 seconds
comes on in the display.
To stop the function, touch
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4
comes on
. The symbol
again and
.
5 6 7 8 9