3.
Adjust the flame after it is regular.
If after some tries the burner does not light, check if the crown and its cap are in correct
positions.
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
WARNING!
Do not keep the control knob pushed for more than 15 seconds.
If the burner does not light after 15 seconds, release the control knob, turn it into off posi-
tion and try to light the burner again after minimum 1 minute.
In the absence of electricity you can ignite the burner without electrical device; in this case
approach the burner with a flame, push the relevant knob down and turn it counter-clock-
wise to maximum gas release position.
If the burner accidentally goes out, turn the control knob to the off position and try to light
the burner again after minimum 1 minute.
The spark generator can start automatically when you switch on the mains, after installa-
tion or a power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol
WARNING!
Always turn the flame down or switch it off before removing the pans off the burner.
Using the Wok Stand
A wok stand is provided to let you to use a round bottomed wok on the hob. You must only
use the wok stand on the Dual Burner and you must not use it with any other type of wok
or pan. When you fit the wok stand, make sure the recesses in the frame fit securely on the
bars of the pan supports.
All manuals and user guides at all-guides.com
4
Operation
1
2
3
.
31