Touch Control Panel - Pando integralcooking E-350 Manuel D'installation

TOUCH CONTROL PANEL

Pushing light button
againthey will be switched off.
On/off Motor; First motor speed; Starting going up trolley; Stopping
going up trolley; Reinstatement of emergency status.
Second speed.
Third speed; Starting going down trolley; Stopping going down
trolley.
Pushing this button the motor keep working at the selected speed
for 15 minute, than all functions will be switched off and trolley will
get down.

To get the cooker hood up keep the button T1 pushed for around 3 seconds; once
the threshold of around 250mm has been exceeded the motor will start working at
first speed, courtesy light will switch on automatically and all other functions
become available.

Pushing the button T1 it is possible to stop and start again the cooker hood going
up until it get on the desired position or until cooker hood trolley will get to upper
end guide.

To get the cooker hood down keep the bottom T3 pushed for around 3 seconds
and to stop the going down, push it again until the desired position

Once it starts going down, if it falls below 250mm height, all functions will be
deactivated.

During the going down, till the threshold of around 250mm has not been exceeded,
all functions are available it is possible to invert the cooker hood running direction
keeping pushed button T1 to get it go up and T2 to get it go down
The emergency status will oc cur in three cases:
1-Opening the cooker hood perimetral panel. To reset the cooker hood, keep
pushed button T1 for 3 seconds.
2-When anti pinch safety system is working during the going down, the cooker
hood will immediately invert the running direction until trolley will get to upper
end guide. In that case, all functions are disabled for about 60 sec.
3-Lock: the hood could lock and will need a reset to unlock. To reset the hood turn
it off (OFF switch) keep off 10" and turn on again (ON switch).
, Leds will be switched on. Pushing it
36