CLAS OM 9391 Mode D'emploi page 14

OM 9391
SILENT BLOCK EXTRACTOR SAF Ø158mm
ASSEMBLY
3.1 Preparing the assembly for the removal of the rubber buff er
The silencer block removal tool (hereinafter referred to as the assembly and removal tool) consists
of a threaded rod (1), two thrust washers (2), a bearing (3), two further thrust washers (2), a cover
plate (4), a receiving tube or sleeve (5) and a nut unit (9), as shown in Figure 1.
Fig. 1 - Identifi cation of tooling components
Before disassembling the silentblock, mount the tool correctly. (1) To do this, place the tool
components on the threaded rod in the order shown (fi g. 2) :
- 2 Axial washers (2)
- Bearing (3)
- 2 Axial washers (2)
- Sealing plate or cover (4)
- Receiving sleeve (5)
centering ring
Fig. 2 - Tool positions for Fig. 3 - Liner side with
disassembly centring device