Operation; General; Recipe Information; Startup - Ovention Double MiLO2-16 Manuel D'installation Et D'utilisation

OPERATION

General

Use the following information and procedures to operate an
Ovention Double MiLO oven.
® ®
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
In the event of emergency, unplug unit.
CAUTION
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Avoid
unnecessary contact with unit.
• Pan/tray will be very hot upon removal—use oven mitt,
pan gripper, or other utensil to remove.

Recipe Information

Double MiLO ovens are designed to provide unequaled flexibility
and efficiency. Each oven chamber/touchscreen combination
has the capability of storing over 4000 custom recipes. Recipes
are organized into categories that group together similar items,
such as lunch recipes or different varieties of pizza.
At initial startup, the Categories screen will show an
"Uncategorized" category and either a sample category or
customer-specific, preloaded categories. If the Categories
screen shows a sample category with recipes, these recipes
can be used to help develop specific recipes appropriate for the
installation. Refer to the "Programming Categories/Recipes"
procedure in this section for instructions on creating recipes
and categories.

Startup

Use the following procedure to start up each oven chamber.
1. Make sure the unit is plugged into a properly grounded
electrical receptacle of the correct voltage, size, and plug
configuration. See the SPECIFICATIONS section for
details.
2. Make sure both circuit
breakers are in the I (On)
position.
3. Make sure each Control
Reset switch is in the I (On)
position.
• Each touchscreen will
energize and show the
logo screen followed by a
progress circle.
• After the software loads,
the Hello screen will appear.
Upper
Circuit
Breaker
"On"
Lower
Circuit
Breaker
"On"
Control
Reset
Switches
"On"
Touch to access
About This Oven screen.
Touch to access
Startup screen and
prepare oven for cooking.
Touch to access
Settings screen.
4. Touch GET STARTED COOKING on the Hello screen
to prepare the oven for cooking. The Startup screen will
appear.
Oven status shown
as "On".
Touch to select
oven setpoint
temperature.
Touch to shut
down oven.
Touch to access
Settings screen.
5. Touch WARM UP on the Startup screen. The Warm Up
Temp screen will appear.
• Several pre-set setpoint temperatures are available.
Touch to shut down oven.
Touch to return to
previous screen
Touch desired
temperature.
Touch to access
Settings screen.
Warm Up Temp Screen
8
English
Hello Screen
Startup Screen
OVMILOM-1022