VINCENT SP-997 Manuel D'utilisation page 24

3. LINE IN:
Input for preamplified mono audio signal
One connector of this input must be connected
with the output socket of the preamplifier for the
desired channel. For example, connected with
"PRE OUT R", if the SP-997 is to be used for the
loudspeaker of the right-hand stereo channel. Only
one of the two input connectors can be used at any
time. The setting "XLR/RCA" must be chosen cor-
rectly. Do not connect any line level sources!
4. AUTO: automatic shutoff
With this switch you can make this main amplifier
switch back into standby automatically 30 minu-
tes after a signal has been detected for the last
time at the socket "LINE IN" (3). This function is
not available in case of a connected Power
Control Cable (6).
Vincent
24
REAR VIEW
3
4
5
6
7
5. SPEAKERS: Loudspeaker terminal
At these output sockets with threaded speaker
clamps one or two loudspeakers can be connec-
ted. Speaker cable with 4 mm banana plugs can
be used.
6. POWER CONTROL: ON/OFF control
These jack connectors (3.5 mm) receive and for-
ward the signal for the standby control (12V
Trigger). As long as there is a cable connected to
one of the "POWER CONTROL" sockets, the
signal via this cable alone decides whether this
main amplifier is active or in standby mode.
7. AC power connector and fuse holder
To establish the power supply, connect the plugs of
the power cable to the device and to the AC wall out-
let. The small plastic housing beneath the plug ope-
ning holds the fuse. Refer to the security precautions.