Preparing For Pvc Slatwall Installation - NewAge Products 40sqft PVC slatwall - Silver Guide D'installation

Preparing for PVC Slatwall Installation

NOTES:
• Insure that you will be installing the PVC
slatwall on a studded structure that is
capable of holding the weight capacities
provided on page 6.
• To get precise cut on a PVC Slatwall Panel, cut
as per recommended below:
For Small cuts, i.e, Cutting a small rectangular
shape for an electric board, use Multi-tool Cutter.
For Large cuts, i.e, cutting the PVC Slatwall panel
into half, use Table Saw.
1
If installing directly on your studded wall/ finished wall. Refer to 1, (A) and (B).
The PVC Slatwall panels are ideal for 16
inches on-centre stud spacing. If you have
A
24 inches on-centre studs, you would be
required to start by trimming the panels to
centre the full install.
16 inch 16 inch
17
16 inch 16 inch 16 inch
1
Tools required.
1 x Stud Finder
1 x Tape Measure
If you are installing on a finished surface
that is not flat or levelled, ensure all your
surfaces are prepared and levelled. There
B
should not be any protruding surfaces as
maximum flatness is desired. Use a Regular
level.
1 x Pencil
1 x Regular Level