Single 40 sqft Slatwall Install
Slide-in the End Trim onto PVC Slatwall side
7
which is closest to wall.
End Trim
Insert the remaining PVC Slatwall panels
9
as shown below. Continue the PVC Slatwall
installation by following step 6 and step 8.
15
(Cont.)
Using a cordless power drill, secure the
8
End Trim (near the corner wall) to the PVC
Slatwall panel using self tapping screws
(at an angle) as shown.
NOTE: Remember to install three Screws
per stud onto the PVC Slatwall Panel.
NOTE: Do not screw the opposite end of the PVC
Panels, as shown below. It is critical to secure
Trims onto the PVC panel using Self Tapping
Screws.
TOP VIEW