NewAge Products 40sqft PVC slatwall - Silver Guide D'installation page 18

Preparing for PVC Slatwall Installation
If you are installing directly on a concrete wall, follow below instructions 2, (C), (D) and (E).
2
NOTE: Hardware for concrete installs are not provided in the 40 sqft. PVC Slatwall kit. You may install
the PVC Slatwall panels directly onto the concrete walls by pre-drilling each hole, inserting concrete
anchors and installing the PVC Slatwall in place. For ease of install, it is recommended to build a stud
wall using 2x4 ft Furring Strips (not included) as shown in the steps below.
C
Ensure concrete surface is flat and levelled.
Once the studded wall has been built, follow the provided installation steps in this Install Guide.
E
Use 1.5 inches long screw for the installs on Furring Strips and not the provided hardware.
16 inch 16 inch
18
16 inch 16 inch 16 inch
Build a 16 inches spaced stud wall using
D
2x4 ft Furring Strips. Ensure the furring
strips are safely secured in place using
3inch long tapcon concrete screws.
3 in. Tapcon
Concrete
Screw
End
Trim
Level
Line
NOTE: Tighten the Tapcon Concrete screws onto
the Furring Strips as per supplier's instructions.
(Cont.)
2x4ft
FURRING
STRIPS