Single 40 sqft Slatwall Install
1
Parts and Tools required.
6 x PVC Slatwall Panels
1 x Cordless
Power Drill
1 x Laser Level
Starting from the middle four studs, install
5
a screw into each one leaving the two ends
of the PVC slatwall panel unscrewed.
NOTE: It is optional to pre-drill holes for
reference of hole locations. You may use a laser
level or Regular level to make sure the panels
are installed straight.
14
Self Tapping
1 x Pencil
Screws
1 x Stud Finder
1 x Drill Bit
End Trims
Self Tapping Screw
Place one PVC Slatwall panel tight against
the wall aligning it to your marked level
4
line. NOTE: You may use a laser level for
ease of install.
Recommended
Height from the oor:
14 inches
Screw the remaining screws in the middle
6
four studs as shown below (3 screws per
stud).Note : do not screw the ends of the
PVC slatwall yet.
Stud
TOP VIEW
Screwing
not required
here
Stud