Installing Backsplash For Fixed Cabinets - NewAge Products BOLD 3.0 Guide D'installation

Masquer les pouces Voir aussi pour BOLD 3.0:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing Backsplash for Fixed Cabinets

Place fixed bottom strip tight
4
against the wall and the top of the
worktop. If your cabinet set does
not have lower cabinets with a
worktop proceed to page 9
Interlock bottom of Slatwall section
with the top of fixed bottom strip.
6
Repeat step 5 to securely fasten
"Slatwall Section".
Interlock Top Magnet Cover on top
8
of the slatwall section and secure
in position with magnets.
Pre-drill 3mm (1/8") holes into each
5
stud then fasten slatwall section to
each wood stud with screws provided.
Repeat steps 5 & 6 for remaining
7
slatwall sections.
Masonry.
Follow steps 4 to 8.
Drill pilot holes through the perforated
strip each 16in with hammer drill &
masonry bit.
Use 2¼" x ¼" Tapcon Concrete Anchor
for each pilot hole. (Not Included)
• OR use #10 x 2" Screw with ⁄ " masonry
plug for each pilot hole. (Not Included)
www.newageproducts.com
7

Publicité

Table des Matières
loading

Table des Matières