Removing Chuck - Skil 2585 Consignes De Fonctionnement/Sécurité

BM 2610915944 1/02 1/21/02
Rotate the clutch ring to the drill bit
symbol " ". Open the chuck all the way,
remove left-hand thread screw inside chuck
by turning it clockwise. Insert the short arm
Always keep the spindle threads, the threads
of the chuck and securing screw free of
RELEASING AND INSERTING BATTERY PACK
Release battery pack from tool by pressing
on both sides of the battery release tabs and
pull downwards. To insert battery, align
CHARGING BATTERY PACK (1 HOUR CHARGER)
Plug charger cord into your standard power
outlet, then insert battery pack into
charger.The charger's green indicator will
begin to "BLINK". This indicates that the
battery is receiving a fast charge. Fast-
charging will automatically stop when the
battery pack is fully charged.
When the indicator light stops "BLINKING"
(and becomes a steady green light) fast
charging is complete.
When you begin the charging process of the
battery pack, a steady green light could also
INDICATOR
LIGHT
11:14 AM Page 9

REMOVING CHUCK

of a 3/8" hex key wrench and close jaws on
flats of wrench. Strike long arm of wrench
sharply counterclockwise, remove wrench
and unthread chuck from spindle (Fig. 2).
INSTALLING CHUCK
debris. To install a chuck, reverse "removing
the chuck" procedure.
battery and slide battery pack into tool until it
locks into position. Do not force.
mean the battery pack is too hot or too cold.
The purpose of the light is to indicate that the
battery pack is fast-charging. It does not
indicate the exact point of full charge. The
light will stop blinking in less time if the
battery pack
discharged.
When the battery pack is fully charged,
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool handle (Fig.3).
BATTERY PACK
-9-
was not completely
FIG. 3
CHARGER