Ul Installation Drawing - PR electronics 9410 Manuel De Produit

LERBAKKEN 10, 8410 RØNDE DENMARK
For safe installation of the Process Control Equipment 9410-U9, the following must be observed.
The module shall only be installed by qualified personnel who are familiar with the national and
international laws, directives and standards that apply to this area.
Model: 9410-U9
Marking:
Proc. Cont. Eq. for Use in Haz. Loc.
Install in CL I DIV2 GP A-D T4
or CL I Zn2 Gp IIC T4
E233311 Installation Drawing: 9410QU01
Standards:
UL 121201 NONINCENDIVE ELECTRICAL EQUIPMENT FOR USE IN CLASS I AND II,

DIVISION 2 AND CLASS III, DIVISIONS 1 AND 2 HAZARDOUS (CLASSIFIED) LOCATIONS
Edition 9 - Revision Date 2018/08/31
CSA C22.2 NO. 213 NONINCENDIVE ELECTRICAL EQUIPMENT FOR USE IN CLASS I

AND II, DIVISION 2 AND CLASS III, DIVISIONS 1 AND 2 HAZARDOUS (CLASSIFIED)
LOCATIONS- Edition 3 - Issue Date 2017/09/01
Revision date:
2019-11-18

UL Installation drawing

Power Control Unit
Version Revision
V1 R0
9410 - Version de produit 9410-001
9410QU01
The 9410-U9 equipment is intended for
installation in non-classified locations or
Class I,Division 2, Groups A – D or Zone 2
Group IIC hazardous locations.
Prepared by:
PB
Page:
1/3
21