How To Handle The Remote Controller; How To Use The Remote Controller Correctly - Toshiba Carrier RBC-AX22CUL Manuel Du Propriétaire

Wireless remote controller kit
8

HOW TO HANDLE THE REMOTE CONTROLLER

• Direct the transmitter of the remote controller toward the signal receiving unit (indoor unit).
When the signal is normally received, "Pi" sound is heard once.
("Pi, pi" sounds are heard only when the operation has started.)
• The standard distance which the signal can be received is approx. 23' (7m).
The distance differs a little according to the capacity of the battery, etc.
• Be careful there is not something to block the signal between the signal receiving unit (indoor unit)
and the remote controller.
• Do not put the remote controller on the place exposed to the direct sunlight or air from the air
conditioner or near the stove, etc.
• Do not drop, throw, or clean with water the remote controller.
• The signal may be accepted in a room where the electronic instantaneous-ON type or inverter type
florescent light is set. For details, contact the shop which you purchased the air conditioner.
n To Use the Remote Controller Setting to Wall, etc.
• Check a signal is received correctly by pushing
• To take off remote controller, pull it toward you.
Fix the remote controller
holder with the screws.
Mounting screw
Truss tapping
Remote controller holder
9

HOW TO USE THE REMOTE CONTROLLER CORRECTLY

• Set the remote controller so that it is not excessively far from the signal receiving
unit (indoor unit), otherwise a malfunction is caused.
Be sure to set the remote controller in the same room where the signal receiving unit (indoor unit)
is installed.
• Direct the remote controller toward the signal receiving unit (indoor unit) for
operation.
When a signal is correctly received, "Pi" sound can be heard.
• Avoid to set the remote controller at a place where it is covered with curtain, etc.
English-11
ON/OFF button at the position to be fixed.
Setting method of
remote controller
Put on.
1
Push.
2
11
Owner's Manual