How To Adjust Air Direction - Toshiba Carrier RBC-AX22CUL Manuel Du Propriétaire

Wireless remote controller kit
5

HOW TO ADJUST AIR DIRECTION

• Never move the louver (Air direction up/down adjusting plate) which is operated on the remote
controller with hands except a case of cleaning of the louver.
• While the unit stops, the louver (Air direction up/down adjusting plate) is closed automatically.
• During preparation of heating, the louver (Air direction up/down adjusting plate) directs upward.
The swinging operation starts after heating preparation status has been cleared.
However, swinging is displayed on the AUTO louver display of the remote controller even if the
heating operation is being prepared.
n How to set up the air direction
Every pushing button during operation, the air direction changes.
n How to start swinging
When pushing button, set the direction of the louver (Air direction up/down adjusting plate) to
the lowest position, and then push
automatically changes upward/downward.
n How to stop swinging
Pushing button once again during swinging of the louver stops the louver at the desired position.
Then, when pushing
• In cooling or dry operation, the louver does not stop when the louver directs downward.
If doing so, the louver stops at the 3
In heating operation
Direct the louver (Air direction up/down
adjusting plate) downward, otherwise the hot air
may not reach at the foot.
In air blowing operation
Display when swinging stopped
English-9
button again, the swinging is displayed and the air direction
button, the air direction can be set to position from the uppermost position.
rd position from the uppermost position.
In cooling/dry operation
Direct the louver (Air direction up/down
adjusting plate) upward, otherwise dewdrops
may adhere or drip down to
near of the discharge grille.
Initial setup
In swing operation
Initial setup
Fan/Heat operation
9
Owner's Manual
Cool/Dry operation
Initial setup
Series of
operation