Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wireless remote controller kit
3
HOW TO OPERATE INDOOR UNIT
n Cool/Heat AUTO
Power supply
Turn on the power supply switch 12 hours before starting the operation.
• After the power supply has been turned on, the operation of the remote controller is not accepted
for approx. 1 minute. It is not a failure.
(The sensor receives the signal once, but the received contents are cleared.)
2
3
4
Push either
or
• During FAN mode, the temperature cannot be set up.
5
Stop
Push ON/OFF button. When using the remote controller to stop the unit, the outdoor unit fan
may keep operating for a while even if the compressor of the outdoor unit has stopped.
• In heating operation, if the room is not comfortably heated with FAN
or
.
Although they are displayed, the function may not be provided according to the used indoor unit.
(Fan speed is constant.)
• When the unit cannot be stopped by the normal operation
Turn off the power switch or leakage breaker, and then contact the shop which you purchased the unit.
n Automatic cool/heat
When all indoor units in the identical refrigerant system are controlled as a group, the cooling/
heating operation is automatically performed with the difference between the setup temperature
and the room temperature.
n Dry operation
• There is no dry function according to the used indoor unit even if DRY is displayed on the
display section of the remote controller. (Same to Cooling operation)
• When the room temperature approaches the setup temperature, running/stop operations are
automatically repeated.
• In order not to return humidity to the room as possible, the mode of indoor fan enters LOW
mode when the operation has stopped.
• The fan speed cannot be adjusted according to the used indoor unit or status of the room
temperature.
• The DRY mode cannot be used according to the used indoor unit when the outdoor
temperature is 59°F (15°C) or lower.
English-7
, Heat
, Dry
, Cool
1
Push
2
Push
1
of
,
3
Push
4
fan speed modes.
When selecting
changed. (During FAN mode, the air speed is not
automatically changed.)
to select the desired temperature.
7
, Fan
. (ON/OFF button)
(Mode button) operation to select one
,
,
, and
.
(Fan Speed button) to select one of
, the fan speed is automatically
Owner's Manual
, select FAN
Publicité
Chapitres
Table des Matières
