Installation Manual; Packaging List; Rbc-Asc11E; Cable Connection - Toshiba RBC-ASC11E Manuel D'installation

Compact wired remote controller

Installation Manual

Packaging list

Appendix
No. Quantity
Name
Compact
remote
controller
1 1
Screw M4
x 25
2 2
Wood
screw
3 2
Requirements of remote
controller installation site
Do not install the remote controller in a place
exposed to sunlight or outside air (near a
window or the like).
The temperature sensor is embedded both
in the remote controller and the indoor unit.
Switch between them for use.
(When delivery, the indoor unit temperature
sensor is used by default.)
When switching to the remote controller
temperature sensor, please follow the
instructions below to ensure that the sensor
can detect the average room temperature. If
not, it is recommended to use the sensor in the
indoor unit.
• Install the remote controller at a place 1-1.5
meters above the ground.
• Do not install the remote controller behind
any obstacles where it cannot detect the
room temperature.
• Install the remote controller only in a room
that uses air conditioner.
• Install the remote controller vertically on the
Used by installation personnel —Electrical operation and maintenance
Appendix
No. Quantity
Name
Installation
Manual
4 1
Owner's
Manual
5 1
Wire
terminal
6 2
Plastic stud
7 2
Model:

RBC-ASC11E

wall or the like.
• Do not install the remote controller at a
place where it will be exposed to the direct
discharge air from the air conditioner.
• Do not install the remote controller on the
wall whose temperature greatly differs from
room temperature.
How to wire the remote controller
■ Wiring Diagrams
Since the remote controller cable has no
polarity, that's ok if the indoor unit's terminal A
and terminal B are inversely connected
• Use non-polarity 2-core cable.
2
• Use 0.5mm -1.5mm

Cable connection

Please use the attached wire connector to
connect the remote controller cable to the
indoor unit terminal board cable.
If crimping tools are not available, please use
other reliable methods for connection. Do
not only use the insulating tape to connect;
otherwise it can be dangerous.
How to install the remote controller
■ Install the remote controller on the wall
Rear case

Remote controller

body
-1-
W：White
2
cable.
B：Black
Wall
Screws