Slide Switch; How To Insert The Batteries - Toshiba Carrier RBC-AX22CUL Manuel Du Propriétaire

Wireless remote controller kit
6

SLIDE SWITCH

• The settings of operation mode display and air direction display vary as follows depending on the
indoor unit in use.
• Use a fine-tipped tool to change the switch setting.
• Push the ACL button after the switch setting is changed.
• Do not change setting of the slide switch because a malfunction occurs by other settings.
1
Louver display switch
Louver display of the
remote controller
Slide switch position
∗ Set the slide switch to "S." Otherwise the air direction
adjustment and louver display are disabled.
2
Operation mode switch
Operation mode display
of the remote controller
Slide switch position
• Before using the air conditioner, check that the slide switch is set as shown in this table.
For details of slide switch setting, contact the dealer from whom you purchased the air conditioner.
7

HOW TO INSERT THE BATTERIES

1. Holding the both sides of the cover and remove it by sliding downward.
2. Correctly insert 2 AAA alkali batteries matching + and - polarities with indications.
3. Push ACL button with something tipped and attach the cover.
• Replace the batteries when the display section of the remote controller
is difficult to be read, or when the signal cannot be sent
if you are not close to the sensor. (The standard replacement time
of the alkali batteries is approx. one year.)
• Use the same type of new batteries for replacing two batteries.
• In case when you do not the remote controller
for a long time, remove the batteries.
S K N
1
A H C
10
Owner's Manual
View with the cover removed
ACL button
SENSOR
ACL
ACL button
Cover
English-10
2