Address - Toshiba Carrier RBC-AX22CUL Manuel Du Propriétaire

Wireless remote controller kit
10

ADDRESS

When the multiple indoor units corresponding to the wireless remote controller are installed
in the same room, an address can be set up to prevent an interference.
Matching the address switch of the sensor with number of the remote controller address, Max.
6 indoor units can be controlled by the corresponding remote controller individually.
It is necessary to set up the address from the wired remote controller when connecting 7 or
more indoor units.
The address switch for receiving the signal is prepared to the sensor (inside of panel or indoor
unit) and the address switch for sending the signal is prepared to the remote controller.
For details, contact the shop which you purchased the air conditioner.
n How to Check the Address
When pushing button on the remote controller, the present address is displayed on the
ADR
display section of the remote controller.
If this address matches with the address of the signal receiving unit (indoor unit), a buzzer
sounds. (When is displayed, buzzer sound is necessarily heard.)
When is displayed, the air conditioner can be operated regardless of any address of the
signal receiving unit (indoor unit). Send the signal by directing the remote controller toward the
signal receiving unit (indoor unit) to be handled.
n How to Match the Address
Setup to remote controller address
1. When keeping
ADR
of the remote controller and the present address is displayed with blinking.
2. Every pushing
ADR
Match one of them with the address switch of the signal receiving unit to be handled.
3. When pushing , the address display goes on and is displayed for 5 seconds.
SET
If the address matches with the address switch of the operation part, the buzzer sounds.
Address
Display of
remote controller
address
∗ Address switch of
Address switch
position of signal signal receiving unit
can be set any position.
receiving unit
• Remove the fixing screw at the rear side of the signal receiving unit and then remove the
cover of the signal receiving unit.
• Turn the knob to the left side for
switch S001.
• Set S002 to the left position (for address
or to the right position (for addresses
pushed for 4 seconds or more,
, the address is exchanged as
Address
1 2 3
4 5 6
S001
S002
!
to while to the right side for
and
!
and
12
lamp goes on at the display section
ADR
!
→ → → ... →
Address
1 2 3
4 5 6
S001
S002
" $
to
"
), to the center (for addresses
$
).
Owner's Manual
$
→
.
Address
1 2 3
4 5 6
S001
S002
of Address select
#
and ),
English-12