Dip Switch Setup - Toshiba RBC-ASCU11-E Manuel D'installation

1. Insert a slot-type screwdriver or the like into
the groove on the lower side of the remote
controller body, and twist it to remove the
rear cover.
2. Cut the plastic stud in the accessory to a
suitable length for filling the gap between
the rear cover of the remote controller and
the studs of the bottom case, and then use
the M4 screws in the accessory to fix the
rear cover to the bottom case through the
stud.
Note 1: Do not tighten the screws too
tightly, otherwise the rear cover will deform.
Note 2: When using studs to fill the gap,
make sure that the rear cover height is
uniform to prevent deformation.
3. Connect the remote controller cable (2-
core) to the cable of the remote controller
body. Confirm the terminal number of
indoor unit and connect the remote
controller cable correctly. (The remote
controller may be damaged if connecting
the power supply of indoor unit.)
4. Hang the remote controller body to the
hook on the rear cover and fix it in place.
Note 3: Allow at least 30 mm of space
around the remote control.

DIP switch setup

The dial switch is located on the circuit board
of remote controller. When switching, remove
the rear cover. But be sure to turn off the air
conditioner power first.
(Factory default)
DIP switch
DIP
1 2
switch
Main
remote
Setting
controller Temperature
Backlight
item
/ Sub
remote
controller
Sub
On
remote Off
controller
Main
Off
remote On
controller
3 4 5
Remote Operation
On/Off
controller indicator
setting button
sensor lamp
Long
1°C On Dim
press
Short
0.5°C Off Bright
press
■ Main remote controller /Sub remote controller: 1
Use DIP switch 1 to set the main/sub remote
controller.
To use the remote controller as a sub remote
controller, slide the switch to the ON position.
To use the remote controller as a main remote
controller, slide the switch to the OFF position.
* For details, please refer to "Multiple Remote
Controller Installation Requirements."
■ Turn off LCD backlight: 2
Use DIP switch 2 to turn off the LCD backlight.
Turn off the backlight when the switch is turned
on, and turn on when the switch is turned off.
■ Temperature setting as unit of 1°C: 3
You can use DIP switch 3 to change the display
unit of temperature setting.
The unit is set to 1°C when the switch is turned
on, and the unit is set to 0.5°C when the switch
is turned off.
■ Remote controller sensor: 4
Use DIP switch 4 to set the remote controller
sensor. If to use the temperature sensor of the
remote controller, slide the switch to the ON
position.
If to use the temperature sensor of indoor unit,
slide the switch to the OFF position.
* For detailed information, please see
"Switching Temperature Sensor."
■ On/Off button setting: 5
Use DIP switch 5 to change the operation
mode of ON/OFF button to long press (approx.
4 seconds or more).
It is set to long press when the switch is turned
on, and it is set to normal (short press) when the
switch is turned off.
■ Operation indicator lamp: 6
Use DIP switch 6 to reduce brightness of
the operation indicator lamp of the remote
controller.
6
Set the lamp to be dim when the switch is turned
on and bright when the switch is turned off.
Multiple remote controller
installation requirements
In a dual remote controller system, one or
more units are operated by multiple remote
controller.
-2-