Function Selection - Hayward HeatPro VS HP50952T Manuel D'installation Et D'utilisation

Function Selection

The status bar is in the upper right corner of the display, the current mode of operation is shown by
Heating
Cooling
From the main interface screen, slide left or right to go to the function selection screens.
Main Interface
Page One Interface This page allows user to select operational mode (Heating, Auto, Cooling), target temperature setting, silent mode and silent timing.
Mode and temperature selection are shown below.
Silent mode and silent timing settings control the unit operation for minimum sound. Operation for minimum sound is accomplished by reducing unit capacity/
output.
Page Two Interface This page allows user to set system time, set ON/OFF timer override, display faults and review and adjust system parameters. Setting
system time is set as follows;
Press "
next time interface
Auto
Indicates the unit is defrosting
Slide Right
Slide Left
Press "Mode"
Press " "
to Quit
Press
"Target Setting"
Press " "
to Quit
Press
"Time Setting"
Press " "
to Quit
" to save
and enter into the
Press " "
to Quit
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Indicates that the screen is locked
Indicates "fault occurred"
Slide Right
Slide Left
Page One Interface
Slide Up
or Down
Press "
to Quit
Slide Up
or Down
Press "
to Quit
Slide Up or
Down for
Press "
to Quit
Slide Up or
Down for
Time
Press " "
to Quit
Page Two Interface
"
"
D-M-Y
"
Press "OK"
to Save
16