Hayward HeatPro VS HP50952T Manuel D'installation Et D'utilisation page 15

Table des Matières

Les langues disponibles

Hayward Omni Connectivity

The HP50952T and HP51202T are Smart Heaters that can be fully controlled by a Hayward Omni pool automation control. These internet enabled controls al-

low you to remotely create schedules and set points for both heating and cooling while displaying real time heater status and diagnostics. The Omni family of

products provide a cable connection used to communicate with the HP50952T/HP51202T and requires firmware revision R4.3.0 or later. Refer to your Omni

Operation manual to the determine current firmware revision as well as instructions on how to upgrade.

Disconnect power to both the heat pump and the OmniLogic before removing their panels. Use a proper outdoor rated 3 conductor 22 AWG cable (20 AWG

for runs over 30 ft) for the connection from the Omni control to the HP50952T/HP51202T. Route the cable through appropriate knockouts making sure they

are not shared with high voltage wiring. Refer to the diagram below showing a Hayward OmniLogic control wired to the heat pump. Note that the position of

each colored conductor is the same at both ends of the communication cable. Use this same wiring method regardless of which Omni control model used.

After the communication cable is fastened and secure, refasten the panels.

Connection at

Omni Control

Green

Black

White

Omni Configuration and Operation

After wiring is complete, power must be applied to the HP50952T/HP51202T for it to be discovered by the Omni control. To add the new heater to your

Omni control's configuration, use the Configuration Wizard for new installations and Quick Edit for existing installations. Progress through the configuration

screens until you get to the Heater section as described in your Omni control's installation manual. Answer "Yes" to the question "Do you want to add a Smart

Heater?". Progress through the following screens until the heater is configured.

Enable / Disable - Slide this switch to en-

able or disable heating/cooling. The setting

will not take effect until the Save button is

touched. To turn on the heater/chiller, adjust

the set point higher or lower than the actual

pool water temperature and then Save. When

the circle icon is grayed out and stationary,

equipment is currently idle. When in motion,

the heater/chiller is actively heating/cooling.

Change Set Point - This slider will raise and

lower the heater/chiller set point setting. The

slider will change the Main set point and

the

slider will change the Solar set point (if

used).

Heat Mode - Heat Mode is enabled if the Heating on/off switch is ON and the Cooling on/off switch is OFF. In Heat Mode, the equipment will ONLY

turn on to heat the pool/spa water.

Cool Mode - Cool Mode is enabled if the Cooling on/off switch is ON and the Heating on/off switch is OFF. In Cool Mode, the equipment will ONLY

turn on to cool the pool/spa water.

Auto Mode - Auto Mode is enabled if the Heating on/off switch and the Cooling on/off switch are both ON. In Auto Mode, the equipment will turn on

to heat the pool/spa water when the pool/spa water temperature is too low, AND to cool the pool/spa water when the pool/spa water temperature

is too high. Auto Mode will turn on the heater/chiller according to the set initial temperature differential. The default initial temperature differential is

set to 2°F.

Connection at Heat Pump

Set Point Temperature - The Main heater/chiller and

Solar set point temperatures are shown in the boxes. The

set-points can be changed using the sliders at the

bottom or by pressing the box and setting the tempera-

ture manually.

set temperature

Main

80°

86°F

water