Color Screen Wire Controller Function Introduction - Hayward HP50AEE Manuel D'installation Et D'instructions

4. USAGE

4.2. Color screen wire controller function introduction

4.2.1 Booting and shutdown
In the main interface：
1) In shutdown status, press the ON/OFF button for 0.5s then the unit will be booted.
2) In booting status, press the ON/OFF button for 0.5s then the unit will be shut down.
Inlet water
20
.5
OFF
Time Temp Seting Outlet Water
07 00 28.5 18.5
4.2.2 Function selection interface
In the main interface, slide left or right to select the function selection.
Inlet Water
Inlet water
20
20
.5
Time Temp Setting Outlet Water
Time Heating Set Outlet Water
07 00 07 00 28.5 28 18.5 18
Main interface
4.2.3 Mode switch
In the Second function interface, click the Mode icon to enter into the Mode Setting interface.
Slide up and down to select the mode (Cooling-Heating-Auto) , click "OK" to save the setting and back
to the previous interface; click Back button "
Mode Mode Temp Setting Temp Setting
SET
Silent Mode Sil t M d d
Sil Silent Timing t Ti i i
Note: when the unit is designed for single Cooling mode or single Heating mode, the mode can not
be switch.
press button
" " 0.5s
Time Time
press button
07 00
07 00
" " 0.5s
slide right
slide left
Sil Silent Mode
Second interface
click Mode icon
click " "to quit
Inlet Water
Inlet water
20
20
.5
Temp Setting Heating Set Outlet Water Outlet Water
28 18
28.5 18.5
slide right
Mode M d Temp Setting T S tti
SET
slide left
t M d Silent Timing Sil t Ti i
" or " " to quit the settings.
Mode
slide up
Cooling
or down
Heating
click "
Time Time Setting Setting Timer
Fault Parameter Parameter
Third interface
Mode
Heating
Auto
Cooling
"to quit
10