Cleaning And Maintenance; Clean The Dust Collector And Filters - EUFY RoboVac R500 Manuel D'utilisation

English
Press to set the "hour" and "minute".
Note: Make sure AM/PM is set correctly.
Press or to save the setting. RoboVac will BEEP ONCE to indicate the
schedule has been set.
To ensure the schedule is set successfully, make sure RoboVac is turned on. You
will hear a beep when the schedule has been set.

Cleaning and Maintenance

For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning/replacement frequency will depend on your usage habits of
RoboVac.
Recommended cleaning/replacement frequency:
RoboVac Part Cleaning Frequency
Dust Collector After each use
Filters Once every week
Rolling Brush Once every week
Side Brushes Once every month
Brush Guard Once every month
Sensors Once every month
Charging Pins Once every month
Swivel Wheel Once every month
18
ON
1
4
Replacement Frequency
-
Every 2 months
Every 6-12 months
Every 3-6 months (or when visibly worn)
Every 3-6 months (or when the silicone
rubber strip on the brush guard becomes
visibly worn)
-
-
-

Clean the Dust Collector and Filters

Press the dust collector release button to pull the dust collector out.
Open and empty the dust collector.
1
Remove the pre-filter by pulling the hooks as shown.
Take out the foam filter and high-performance filter.
Clean the dust collector and filters with a vacuum cleaner or a cleaning brush.
Put the filters and pre-filter back together in the dust collector.
English
2
19