Set Time And Scheduled Cleaning; Cleaning And Maintenance - EUFY RoboVac 30 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
English

Set Time and Scheduled Cleaning

Set Time
Make sure the time is set correctly to your local time before setting a scheduled cleaning.
Make sure the main power switch on the bottom of RoboVac is turned on.
Press
on the remote control. The time will blink on the display.
Press
to set the "hour" and "minute".
Note: Make sure AM/PM is set correctly.
Press
or
to save the setting. RoboVac will BEEP ONCE to indicate the time has
been set.
To ensure the time is set successfully, make sure RoboVac is turned on. You will hear
a beep when the time has been set.
Set a Scheduled Cleaning
You can schedule RoboVac to start cleaning at a specified time. To cancel a previously
scheduled cleaning, press and hold
for 3 seconds until RoboVac beeps twice and
disappears.
Note: Before setting a scheduled cleaning, make sure the time has been set correctly to
your local time; refer to the previous section "Set Time" for how to set the time.
Make sure the main power switch on the bottom of RoboVac is turned on.
Press
on the remote control.
will blink on the display.
18
ON
Press
to set the "hour" and "minute".
Note: Make sure AM/PM is set correctly.
Press
or
to save the setting. RoboVac will BEEP ONCE to indicate the
schedule has been set.
To ensure the schedule is set successfully, make sure RoboVac is turned on. You
will hear a beep when the schedule has been set.

Cleaning and Maintenance

For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning/replacement frequency will depend on your usage habits of
RoboVac.
Recommended cleaning/replacement frequency
RoboVac Part
Cleaning Frequency
Replacement Frequency
Dust Collector
After each use
-
Filters
Once every week
Every 2 months
Rolling Brush
Once every week
Every 6-12 months
Side Brushes
Once every month
Every 3-6 months (or when visibly worn)
Brush Guard
Once every month
Every 3-6 months (or when the silicone
rubber strip on the brush guard becomes
visibly worn)
Sensors
Once every month
-
Charging Pins
Once every month
-
Swivel Wheel
Once every month
-
English
ON
1
4
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Robovac 30 t2116

Table des Matières