Set Time And Scheduled Cleaning; Cleaning And Maintenance - EUFY RoboVac T2108 Manuel D'utilisation

Masquer les pouces Voir aussi pour RoboVac T2108:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38
English

Set Time and Scheduled Cleaning

Set Time
Make sure the time is set correctly to your local time before setting a scheduled cleaning.
Make sure the main power switch on the bottom of RoboVac is turned on.
Press
on the remote control. The time will blink on the display.
Press
to set the "hour" and "minute".
Note: Make sure AM/PM is set correctly.
Press
or
to save the setting. RoboVac will BEEP ONCE to indicate the time has
been set.
To ensure the time is set successfully, make sure RoboVac is turned on. You will hear
a beep when the time has been set.
Set a Scheduled Cleaning
You can schedule RoboVac to start cleaning at a specified time. To cancel a previously
scheduled cleaning, press and hold
for 3 seconds until RoboVac beeps twice and
disappears.
Note: Before setting a scheduled cleaning, make sure the time has been set correctly to
your local time; refer to the previous section "Set Time" for how to set the time.
Make sure the main power switch on the bottom of RoboVac is turned on.
Press
on the remote control.
16
ON
will blink on the display.
Press
to set the "hour" and "minute".
Note: Make sure AM/PM is set correctly.
Press
or
to save the setting. RoboVac will BEEP ONCE to indicate the
schedule has been set.
To ensure the schedule is set successfully, make sure RoboVac is turned on. You
will hear a beep when the schedule has been set.

Cleaning and Maintenance

For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning/replacement frequency will depend on your usage habits of
RoboVac.
Recommended cleaning/replacement frequency:
RoboVac Part
Cleaning Frequency
Dust Collector
After each use
Filters
Once every week
Rolling Brush
Once every week
Side Brushes
Once every month
Sensors
Once every month
Charging Pins
Once every month
Swivel Wheel
Once every month
English
ON
1
4
Replacement Frequency
-
Every 2 months
Every 6-12 months
Every 3-6 months (or when visibly worn)
-
-
-
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Robovac t2109Robovac t2110

Table des Matières