Water Discharge; Probe; Cookware & Reservoir - Monogram ZMB9031SNSS Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CARE AND CLEANING

WATER DISCHARGE

This cycle is called for anytime steam has been used and
the oven is turned off. The following message will appear
on the display: NEED TO DISCHARGE/OPEN THE
DOOR.
Carefully open the door as hot steam will be released.
A message will appear on the display to pull the water
reservoir partially out to the arrow on the side of the
reservoir and press SELECT.
This function will take 2-3 minutes to pump water out of the
internal steam circuit of the oven and into the reservoir for
disposal. Pump noises during this cycle are normal.
CLEANING FINISHED
RESIDUAL HEAT

PROBE

The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a
soap-filled scouring pad, rinse and dry.
To order additional temperature probes, see the
Accessories and Consumer Support sections at the end of
this manual.
during a steam clean cycle.
COOKWARE & RESERVOIR
The water reservoir, racks, pans, and lids that came with
your steam oven are all dishwasher safe. However, baked
on foods may require washing by hand.
Do not store soiled cookware anywhere in the oven.
Always properly dispose of excess grease.
20
190°F
At the end of the discharge cycle, the message
DISCHARGE ENDED REMOVE AND EMPTY THE TANK
will appear on the display, confirming that the discharge
was successful.
When the oven has cooled, you should wipe up any
remaining water on the door or cavity with a dry soft cloth.
Whether or not you wish to immediately repeat a new
steam cooking cycle right away, it is recommended to
empty the reservoir, dry it, reinsert the reservoir, and close
the door. Fill the reservoir with fresh water each time
before starting a steam mode. The oven is now ready for a
new cooking cycle.
IMPORTANT: If the electricity is interrupted during a steam
mode, the oven requires you to complete a discharge cycle
once it turns back on.
Keep the temperature probe plug in the socket in the oven
when not using the temperature probe.
49-2000696 Rev.1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zmb9032snssZmb9031Zmb9032

Table des Matières