Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

FITTING INSTRUCTIONS FOR AB0002BK ADVENTURE BARS
KAWASAKI GTR 1400 2010-
PICTURE ONE
PICTURE TWO
THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.
DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.
Please note that the way the kit is packed does not necessarily represent the way of
mounting to the bike
T
(
)
HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY
FOR CLARITY OF INSTRUCTIONS ONLY
2
1
3
1 4
1
5
6
7
8
9
LEFT HAND SIDE
R&G Racing
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
www.rg-racing.com
Email:
info@rg-racing.com

Publicité

loading

Sommaire des Matières pour R&G AB0002BK

  • Page 1 FITTING INSTRUCTIONS FOR AB0002BK ADVENTURE BARS KAWASAKI GTR 1400 2010- PICTURE ONE PICTURE TWO THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. Please note that the way the kit is packed does not necessarily represent the way of...
  • Page 2: Right Hand Side

    THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. RIGHT HAND SIDE LEGEND ITEM 1 = ADVENTURE BAR LEFT-HAND SIDE (CB008) (x1). ITEM 2 = UPPER SPACER LEFT-HAND SIDE (S0319) (45mm LONG) (x1). ITEM 3 = M12 NYLOC NUTS, TWO PER SIDE (x4).
  • Page 3 PICTURE THREE Left-hand side (as you sit on bike) • Remove the two nuts in position arrowed in picture THREE. • Using the longer engine bar (ITEM 7) and a soft-faced mallet, gently drive out the upper original engine bar leaving the same length of new engine bar protruding from both sides (ensure the original bar does not fall or cause any damage).
  • Page 4 Right-hand side (as you sit on bike) • Remove the cap head bolt in position arrowed in picture TWO. • Carefully offer the right hand adventure bar (ITEM 10) up to bike feeding the front mounting through the vents in the side fairing as shown in picture TWO. •...
  • Page 5: Outils Necessaires

    FRANCE INSTRUCTIONS DE MONTAGE DES PARE CARTER AB0002BK KAWASAKI GTR 1400 2010- R&G ’ ’ A PRESENTATION DES PIECES DANS L EMBALLAGE N EST PAS TOUJOURS IDENTIQUE AU SENS DE MONTAGE Merci de noter que dans le cas où les protections sont assemblées avec une bague en caoutchouc, merci de bien vouloir le retirer lors du montage des pièces sur la moto.
  • Page 6 R&G et d’origine. Attention à ne pas abimer le bocal de liquide de frein arrière en chassant l’axe inférieur. • L’axe R&G devra dépasser de manière égale de chaque côté de la moto. • Placez l’entretoise (Art 2-45 mm) sur l’axe supérieur côté gauche •...