Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
FITTING INSTRUCTIONS FOR CRASH PROTECTOR
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!
Right hand side
•
Remove fairing (disconnect indicator wiring plug)
•
Remove front most engine mounting bolt (catch nut)
•
Undo and remove lower radiator bolt and move radiator slightly forward
•
Feed 80mm long M10 hex head bolt from kit (shortest) from inside (with 10mm washer at hex end) to
replace engine mounting bolt
•
Screw on (tighten to required torque using 19mm socket) right-hand steel spacer (shortest) hex to out side
•
Fit marking tool into spacer (10mm thread) leaving approximately 25mm exposed
•
Replace fairing and wind tool out to make contact with inside of fairing, press on fairing in order to make an
impression on the inside of the panel
•
Remove fairing
•
Pilot drill centre of impression mark made by tool (drill inside outwards)
•
Refit fairing and ensure that pilot hole lines up with marking tool point
•
Remove fairing and marking tool (tool to be used on other side)
•
Carefully Drill fairing using a 28mm tank cutter
•
Refit fairing panel and connect indicator wiring plug
•
Screw on bobbin, torquing up the M10 hex head x 60mm long bolt, not forgetting washer
Left hand side
•
Repeat as above, except using the longer of the two hex head bolts and the longer steel spacer
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
TRIUMPH DAYTONA 675 '06 ONWARDS
/cone cutter
R&G Racing
(hole saw), from outside inwards debur hole
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
Manuels Connexes pour R&G ABCP0173
Sommaire des Matières pour R&G ABCP0173
- Page 1 FITTING INSTRUCTIONS FOR CRASH PROTECTOR TRIUMPH DAYTONA 675 ’06 ONWARDS Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber washers should be thrown away! Right hand side •...
- Page 2 CONSUMER NOTICE The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular purposes.
- Page 3 Notice de montage CP0173 TRIUMPH DAYTONA 675 2006-> Percage 28 mm D et G Le sens de montage n'est pas identique au sens présenté dans l'emballage, merci de suivre les instructions ci dessous. Dans le cas où les kits sont emballés avec un joint torique, celui-ci doit être retiré avant le montage.