Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENG
Getting Started
Before first use, the battery
y
according to the diagram in the figure.
Install the battery
y
A pictogram in the form of a "dot" on the battery should
be on the left. You will hear a click when the battery is
placed correctly.
Open the lens covers (2).
y
Press the ON/OFF button
y
on.
Adjust the interpupillary distance with the rings
y
moving the eyepieces farther or closer to each other.
Adjust the symbol sharpness on the displays by rotating
y
the eyepiece dioptre rings (12). In future, it will not be
necessary to rotate the eyepiece dioptre rings, regardless
of the distance and other conditions.
To focus on the object being observed rotate the lens
y
focusing ring (10).
Select the calibration mode: manual (M), semi-automatic
y
(SA) or automatic (A) in the main menu (enter the menu
by long pressing the MENU button (9).
Calibrate the image with a short press of the ON/OFF
y
button
(4)
(when calibration mode (SA) or (M) has been
selected). Close the lens cap before manual calibration.
Select the required amplification level ("Normal", "High",
y
"Ultra") by briefly pressing the UP button (7).
10
Quick Start Guide
(11)
should be charged
(11)
into the battery compartment (14).
(4)
briefly to power the device
Adjust the brightness, display contrast, smooth digital
y
zoom in the quick menu (activate by briefly pressing the
MENU button (9).
Press the LRF button
y
The rangefinder reticle will appear in the center of the
image (the rangefinder mark appears in the centre of
the image). Briefly press the LRF button
the distance. Press and hold down the LRF button
2 seconds to measure the distance in scan mode. If the
rangefinder is idle longer than for 4 seconds, it turns off
automatically.
After use, press and hold down the ON/OFF button
(13)
by
y
turn the device off.
Note: To prevent accidental decamouflage of the user, the
displays automatically turn off when the observer moves
the device away from the face.
When the device approaches the face, the displays will
automatically turn on.
Button Operation
(4)
ON/OFF button
Device is off: Power on the device: short press of the
Device is on: Power off the device: long press of the
(6)
briefly to start the rangefinder.
(6)
ON/OFF button (4).
ON/OFF button
(4)
for longer than 3
seconds.
to measure
(6)
for
(4)
to
Publicité
Table des Matières
