Edge Band Trimming - Festool OF 1010 REQ-F Notice D'utilisation

English
7
7-3
7-2
7-1
7-4 7-5 7-6
8
Copying ring
When choosing the size of the copying
ring [4-1], ensure that the cutter [4-2] being
used fits through its opening.
► Secure the copying ring to the router table
from below in place of the covering
ring [8-1].
Excess Y (figure [4]) of the workpiece to the
template is calculated as follows:
Y = (copying ring diameter - cutter diameter)/2
The copying ring can be exactly centred with the
ZD-OF centring mandrel (accessory).
Copying device
The copying device requires the angle arm WA-
OF [7-2] and the copier scanning set KT-OF,
consisting of a roller support [7-6] and three
copying rollers [7-7].
14
► Use the rotary knob [7-1] to tighten the an­
gle arm to the required height on the
threaded hole [7-3].
► Fit a copying roller to the roller support and
use the rotary knob [7-5] to tighten it on the
angle arm. Make sure that the copying roll­
er and the router have the same diameter.
► The distance between the feeler roller and
the cutter axis can be adjusted by turning
the adjusting wheel [7-4].
9.6

Edge band trimming

Protruding edge bands can be flush trimmed
7-7
with the angle arm WA-OF [9-2] in connection
with the guide plate UP-OF [9-5] (accessory).
► Screw the angle arm into the platen's
threaded bore [9-1] with the rotating
knob [9-3].
► Bolt the guide plate to the angle arm with
the rotating knob [9-4].
► Adjust the milling depth so that this is equal
to the thickness of the edge band +1/16"
(2 mm).
Move the guide plate [10-1] as close as
►
possible to the cutter by loosening the ro­
tating knob [10-3].
► Adjust the depth of the guide plate with the
8-1
adjusting wheel [10-2] so that during trim­
ming a few decimillimetres of the edge
band are left protruding which can then be
sanded down by hand.
9
9-3
9-1 9-2
9-4 9-5