Routing With The Fs Guide System; Copy Cutting - Festool OF 1010 REQ-F Notice D'utilisation

5
5-3
5-2
5-1
This distance can be adjusted faster and more
precisely with the fine precision adjust­
ment [5-6] available as an accessory:
► Turn the adjusting screw [5-5] in the plastic
part of the guide.
► Clamp the guide rods with the rotating
knobs [5-1] in the precision adjustment.
► Loosen the rotating knobs [5-2] of the par­
allel guide.
► Set the desired distance with the adjusting
screw and retighten the rotating knobs.
For better extraxtion, a special suction
hood is available as an accessory for the
side stop.
9.3

Routing with the FS guide system

The guide system (available as an accessory)
makes it easier to route straight grooves.
► Secure the guide rail adapter [6-4] to the
router table using the guide rods [6-3] of
the parallel side fence.
► Secure the guide rail [6-6] to the workpiece
using fastening clamps [6-7].
Ensure that there is a safety distance X of
(see figure [6]) 7/32" (5 mm) between the
front edge of the guide rail and the cutter,
or the groove.
► Place the guide rail adapter on the guide
rail, as shown in figure [6]. To ensure that
the router stop can be guided without play,
use a screwdriver through the top open­
ings [6-5] on the side to adjust the two
guidance jaws.
► Tighten the height-adjustable support [6-2]
on the threaded hole of the router table so
that the underside of the router table is par­
allel to the workpiece surface.
5-3
5-4
5-2
5-5
5-1
5-6
6-2
5-7
6-1
When working with marking-up lines, the
marks on the platen [6-1] and the scale on the
support [6-2] show the centre axis of the cutter.
For a more precise setting, a fine adjust­
ment is available as an accessory for the
guide system.
9.4 Routing with the beam compasses
With the SZ-OF 1000 beam compasses (acces­
sory) you can make circular cuts or segments
of circles with diameters from 6-1/32 to 29-7/8"
(153 to 760 mm).
► The beam compasses are pushed into the
front groove of the platen until the desired
radius is set.
► Lock the beam compasses with the rotating
knob [1-4].
To prevent the tip of the compasses
from making a hole in the workpiece,
fix a thin board at the centre point by
means of double-sided adhesive tape.
9.5

Copy cutting

A copying ring or the copying device is used to
exactly reproduce existing workpieces (acces­
sories).
English
6
6-3
6-4
6-5
6-6
X
6-7
13