Health Hazard By Dust - Festool OF 1010 REQ-F Notice D'utilisation

English
Keep cutting tools sharp and clean. Prop­
f.
erly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
Use the power tool, accessories and tool
g.
bits etc. in accordance with these instruc­
tions, taking into account the working con­
ditions and the work to be performed. Use
of the power tool for operations different
from those intended could result in a haz­
ardous situation.
Keep handles and grasping surfaces dry,
h.
clean and free from oil and grease. Slip­
pery handles and grasping surfaces do not
allow for safe handling and control of the
tool in unexpected situations.
5 SERVICE
Have your power tool repaired by qualified
a.
specialists only and always use original
spare parts. This ensures that the safety of
the power tool is maintained.
Only use original parts for repairs and
b.
maintenance. The use of incompatible ac­
cessories or spare parts can result in elec­
tric shocks or other injuries.
3.2 Machine-specific safety notices
Hold the power tool by insulated gripping
–
surfaces only, because the cutter may
contact its own cord. Cutting a "live" wire
may make exposed metal parts of the pow­
er tool "live" and could give the operator an
electric shock.
Use clamps or another practical way to se­
–
cure and support the workpiece to a stable
platform. Holding the work by your hand or
against the body leaves it unstable and may
lead to loss of control.
Only cutters provided by Festool for this
–
purpose may be mounted on the power
tool. The use of other cutters is prohibited
due to the increased risk of injury.
The maximum rotational speed specified
–
on the tool must not be exceeded or the
rotational speed range must be observed.
Accessories that rotate faster than the per­
missible level can rupture.
Wait until the power tool has come to a
–
complete halt before placing it down. The
insertion tool can get caught and lead to a
loss of control of the power tool.
– In the case of materials to be processed
which can become statically charged or
lead to static charging, a dissipative overall
8
system consisting of an antistatic suction
hose (AS) and extraction mobile must be
used.
– Do not clamp tools with an unsuitable
shank diameter in the clamping collet.
– Only use tools that meet standard
EN 847-1. All Festool routing tools fulfi l
these requirements.
– Ensure that the router bit is seated firmly
and that it runs perfectly.
– The clamping collet and locking nut must
not show any signs of damage
– Do not use cracked or deformed router
bits.
–
Wear suitable personal protective equip­
ment: Ear protection, protective goggles,
dust mask for work that generates dust,
protective gloves for working with rough
materials and for changing tools.
3.3 Sawing aluminium
When sawing aluminium, the following meas­
ures must be taken for safety reasons:
– Install an upstream residual-current circuit
breaker (RCD, PRCD).
– Connect the power tool to a suitable dust
extractor with an antistatic suction hose.
– Regularly clean dust deposits from the mo­
tor housing on the power tool.
– Wear protective goggles.
3.4

Health hazard by dust

WARNING! various dust created by pow­
er sanding, sawing, grinding, drilling and
other construction activities contains chemicals
known (to the State of California) to cause can­
cer, birth defects or other reproductive harm.
Some examples of these chemicals are:
– lead from lead-based paints,
– crystalline silica from bricks and cement
and other masonry products, and
– arsenic and chromium from chemically
treated lumber.