Publicité
Ford Transit
04/2000 - ....
Ref. 1242
Fitting instructions
1)
Remove the spare wheel and remove the bolts from the bumper support.
Insert by (A'), on both sides, the bolts with washers through the outside of the chassis beam. Place along
2)
the inner side the mounting pieces (-f) on the inserted bolts and place the pieces (-i) and (-j) with (A) and
(A') on the liberated drillings of the bumper support (see photo 1-2).
Insert the bolts without tightening.
Place the tow bar, for bumper without mounting step, with points (D) and (D') of the pieces (-i) and (-j)
3)
(see drawing 1). When bumper with mounting step, place points (D) of the tow bar on points (D) of the
pieces (-i) and (-j) (see drawing 2). Place afterwards the reinforcement pieces (-k) and (-l), on the outside
on points (D) and (D'). Insert the bolts and tighten everything firmly (see tension).
Assemble the ball on the holes (*-*'). Use the plate (5) only for the assemblage of 50V and rockinger
4)
(see fig. 4). Replace the spare-wheel.
Composition
1 tow bar reference 1242
6 bolts M12x100 - DIN931
10 nuts M12 - DIN934
6 bolts M12x45 - DIN931
2 washers ø37x13x3 – DIN9021
12 security washers M12 - DIN128A
2 mounting pieces (-f)
1 mounting piece (-i) (fig. 1)
1 mounting piece (-j) (fig. 1)
1 reinforcement piece (-k) (fig. 2)
1 reinforcement piece (-l) (fig. 2)
1 socket holder P29
1 bolt M10x25 – DIN933
1 nut M10 – DIN934
1 security washer M10 – DIN128A
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(A-A')
(A-A'-D)
(D-D')
(A')
(A-A'D-D')
(A')
(D-D')
(D-D')
(D-D')
(D-D')
(-p)
(-p)
(-p)
(-p)
All bolts and nuts: quality 8.8
Publicité
