Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3-wire connection: Direct Wire
Use this method only if local codes permit connecting ground
conductor to neutral supply wire.
1. Pull the wires through the conduit on cord/conduit plate on
bottom of range. Allow enough slack to easily attach the
wiring to the terminal block.
When direct wiring, relocate the conduit bracket so the left
■
hole is centered beneath the terminal block.
A
D
E
A. Terminal block
B. Ground-link screw
C. Conduit Bracket
D. Line 2 (red) wire
E. Bare (green) ground wire
2. Attach terminal lugs to line 2 (red), bare (green) ground, and
line 1 (black) wires. Loosen (do not remove) the setscrew on
the front of the terminal lug and insert exposed wire end
through bottom of terminal lugs. Securely tighten setscrew to
torque as shown in the following Bare Wire Torque
Specifications chart.
C
D
A. Terminal lug
B. Setscrew
C. Line 2 (red) wire
D. Bare (green) ground wire
E. Line 1 (black) wire
Bare Wire Torque Specifications
Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3
N-m).
W
i
e r
A
w
g
8 gauge copper
6 gauge aluminum
12
B
C
G
H
F
I
F. Line 1 (black) wire
G. Removable retaining nut
H. Power Cord Strain Relief
I. Direct Wire Strain Relief
A
B
E
T
o
q r
u
e
25 lbs-in. (2.8 N-m)
35 lbs-in. (4.0 N-m)
3. Use ³⁄
" nut driver to connect the bare (green) ground wire to
8
the center terminal block post with one of the 10–32 hex
nuts.
A
B
A. 10–32 hex nut
B. Line 2 (red)
C. Ground-link screw
4. Connect line 2 (red) and line 1 (black) wires to the outer
terminal block posts with 10-32 hex nuts.
5. Securely tighten hex nuts.
6. Replace terminal block access cover.
Verify Anti-Tip Bracket Is Installed
and Engaged
1. Place the outside of your foot against the bottom front
of the drawer, and grasp the lower right or left side of the
backguard as shown.
NOTE: If your countertop is mounted with a backsplash, it
may be necessary to grasp the range higher than is shown
in the illustration.
2. Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
3. If the rear of the range lifts more than ½" (1.3 cm) off the floor
without resistance, stop tilting the range and lower it gently back
to the floor. The range foot is not engaged in the anti-tip bracket.
IMPORTANT: If there is a snapping or popping sound when
lifting the range, the range may not be fully engaged in the
bracket. Check to see if there are obstructions keeping the range
from sliding to the wall or keeping the range foot from sliding
into the bracket. Verify that the bracket is held securely in place
by the mounting screws.
F
E
D
C
D. Bare (green) ground wire
E. Line 1 (black)
F. Terminal lug
Publicité
Table des Matières
