Driver Installation; Wireless Connection - Speedlink TORID Mode D'emploi

First, charge the gamepad. Using the mini-USB cable, connect it to
any free USB port on your PC, console or other USB power source
(min. 500mA). The gamepad's LED ring will flash during charging
which takes up to 3 hours. Please be aware that the initial charge
may take a little longer. As soon as the LED ring stays lit, charging
is complete and you can disconnect the cable.
To use the gamepad on the PC, insert the supplied driver CD into
the CD drive to install the driver software. If the installation process
does not start automatically, use Windows* Explorer to navigate to
your CD drive and start the program 'Setup.exe'. You need to install
the driver software to use the vibration function with some games.
For the best possible performance, always use the latest driver
version which you can download from the SPEEDLINK
You do not need to install the driver if using the
Plug the USB receiver into any free USB port on your PC or PS3*.
The device will be detected automatically and ready to use
If the gamepad is switched off, keep the "HOME" button held
depressed for three seconds to switch it on. The gamepad's LED
If using the gamepad for the first time, press the button again
briefly to establish the connection to the PC or console – when
doing so, make sure the gamepad is close to the receiver. The
connection process takes a few seconds, but once done the
1. CHARGING

2. DRIVER INSTALLATION

website at www.speedlink.com.
gamepad on the PS3*.
3. CONNECTING
in just a few seconds.

4. WIRELESS CONNECTION

ring will then start to flash.
EN