Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Aquasystem®
programme
activation
If the remote control
fails to activate or
where the smallest
LED light
flashes, the battery must be
charged (refer to the Chapter.
ing the J.touch remote
control")
Once on, the J.touch remote control,
where not used, switches off after
about 15 seconds; to turn it on again,
lightly shake it
the programmes
(AQS)
Fill the tub, turn on the main switch and hold down the key displayed until the function keys
come on (the battery charge level and value - indicative of the water temperature - are also
briefly presented).
"Charg-
Keep the key displayed held down: the key will flash, indicating that the start-up pro-
cedure is underway.
When the flashing stops and the light becomes brighter, the function starts (the
"dream" programme is activated).
selecting
To select a different programme than the one offered, press, in sequence, the "AQS" key
(you must wait a few seconds before the new programme begins).
36
S
imply press the J.touch remote control keys to select from
the four different hydromassage programmes available:
- Silence
;
- Breath
;
- Dream
;
- Renew
;
Naturally, each programme is personalised to satisfy tastes.
35
Dream
1
Silence
4
35
Breath
2
Renew
3
Publicité
Table des Matières
