Safety Regulations - Beta 3065/40-20T Mode D'emploi

INSTRUCTIONS FOR USE
FOREWORD
Dear Customer, before using your new jack, please read these instructions carefully and familiarise yourself with
the safety symbols.
- This manual is an integral part of the machine, and as such must be kept safe and to hand so the operator is able to
consult it whenever needed.
- The contents of this manual comply with the Machinery Directive 2006/42/EC, and the jack is type approved in
conformity with European Standard EN 1494, as amended.
 7KH PDQXIDFWXUHU UHVHUYHV WKH ULJKW WR PDNH PRGL¿FDWLRQV ZLWKRXW SULRU QRWLFH ZLWKRXW SUHMXGLFH WR WKH VDIHW\ DQG
main technical characteristics, and shall bear no liability in such an event.
- Failure to observe these instructions may result in personal injury or even death.
- The manufacturer shall not be liable for any damage or injuries caused by incorrect or improper use of the product.
7KH LGHQWL¿FDWLRQ SODWH LV RQ WKH VLGH RI WKH FDVLQJ DWG. 1

SAFETY REGULATIONS

- Only authorised personnel are allowed to use the equipment and they must know the contents of this operating
and maintenance handbook.
-The jack is an apparatus for lifting only and not for supporting, it is therefore absoltely forbidden to work in any
way under the vehicle being lifted until it is placed on the relative stands. DWG. 2
- Before starting to lift a vehicle it has to be blocked with the parking brake and/or by putting wedges under the
ZKHHOV DV LOOXVWUDWHG LQ ¿JXUH DWG. 3
- If the vehicle is loaded check load stability when lifting.
- Place the jack so that the load is centred over it and where the gripping points are indicated by the vehicle ma
nufacturer. DWG. 4
- During lifting and lowering, it is necessary to check there are no persons or animals under the suspended load
or in the vicinity.
- Before lowering the load make certain the handle is in the horizontal position. DWG. 5
- Never lift loads on sloping, uneven or soft ground. DWG. 6
- If extensions are needed use only those supplied by the manufacturer with the jack.
Do not use extensions without the relevant plate. Never use more than two extensions. DWG. 7
 'R QRW OLIW WKH ORDG LQ D FRQ¿QHG VSDFH VR DV QRW WR UXQ WKH ULVN RI JHWWLQJ WUDSSHG DWG. 8
- It is forbidden to use more than one jack simultaneously on the same load.
- Never tamper with the pressure relief valve that has the guarantee seal. DWG. 9
- Do not leave any pressure in the pistons at end of stroke when there is no load
ART. 3065/40-20T AIR-HYDRAULIC JACK
EN
7