Case 3 : Component Video Output Jacks; Other Type Of Connecting The Audio Output Cable; Case 1 : Connecting To Your Tv; Case 2 : Connecting To A Stereo Amplifier With Av - Samsung DVD-R128 Mode D'emploi

Case 3 : Component Video

output jacks

1. Connect Component video cables(not supplied)
between the COMPONENT OUT(Y,P
DVD Recorder and COMPONENT IN(Y,P
on your TV.
2. Connect audio cables (white and red) between the
AUDIO OUT jacks on the DVD Recorder and AUDIO
IN jacks on TV (or AV amplifier).
(See pages 21-22).
3. After connecting, refer to the page 34 to 35.
You will enjoy high quality and accurate colour
●
reproduction images.
green
blue
red
Make sure that the colour coded
■
connections match. The Y, P
NOTE
component output jacks of your DVD
Recorder must be connected to the exact
corresponding component input jacks on
your TV.
Progressive setting is only available when
■
the Video Out is set to Component.
(See page 34)
Other type of connecting
the Audio output cable
,P ) jacks on
B R
,P ) jacks
B R
There are several ways to output audio signal not using
scart cables. Select the audio connection that best suits
you below.

Case 1 : Connecting to your TV

●

Case 2 : Connecting to a stereo amplifier with AV

●
Case 3 : Connecting to an AV amplifier with a
●
Manufactured under licence from Dolby
Laboratories. "Dolby" and the double-D symbol
are trademarks of Dolby Laboratories.
"DTS" and "DTS Digital Out" are trademarks of
DTS, Inc.
Case 1 : Connecting to your TV
If your TV has audio input jacks, use this connection.
, P
B R
output jacks
digital output jack
yellow
white
red
21
English -