Remote Control Unit - Samsung DVD-R128 Mode D'emploi

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are empty.
Checkpoint 2
Check for the TV/DVD selection button.
Checkpoint 3
Other
I forgot my password for parental supervision.
Press and hold down the PROG (
Checkpoint 1
buttons on the front panel of the DVD
Recorder simultaneously for more than 5
seconds with no disc in the DVD Recorder.
All settings including the password will
revert to the factory settings. Do not use
this unless absolutely necessary. (Note that
this function is possible only when no disc
is inserted.)
Is it possible to change a subtitle and an audio sig-
nal on a recorded disc?
A recorded disc is played with only the
Checkpoint 1
subtitle and the audio signal which
were selected during recording.
Other problems.
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, follow the instructions
given.
Checkpoint 2 Turn your DVD recorder off and on.
If the problem still persists, contact a
Checkpoint 3
nearby Samsung service centre.
)
89
English -