Antenna + DVD Recorder +
external decoder box + TV
If you connect external decoder box to DVD recorder,
you can record scrambled channels (CANAL+or
Premiere broadcasts) received through the built-in TV
tuner in DVD Recorder.
1. Connect RF antenna cables as shown.
2. Connect the AV1 connector on this recorder to the
SCART AV connector on TV using a SCART cable.
3. Connect the AV2 connector to a SCART AV
connector on decoder box.
4. To watch or record PAY-TV Canal Plus programmes,
set your DVD Recorder to receive the channels using
the on-screen display.(Refer to page 28)
Wall
DECODER
Other type of connecting
the Video output cable
There are several ways to output video signal not using
scart cables. Select one of the following video
connecting that best suits you below.
Case 1 : Connecting to a Video (Composite) output
●
jack
Case 2 : Connecting to an S-Video output jack
●
Case 3 : Component Video output jacks
●
S-Video, Component video and Progressive
Output Modes
S-Video and Component video output are available
●
only if your TV supports S-Video input or Component
video input, respectively. If S-Video or Component
video output does not work, check the TV
connections and the TV input selection settings.
Compared to standard interlaced video, progressive
●
scan doubles the amount of video lines fed to your
TV, resulting in a more stable, flicker-free, clear
image than interlaced video.
This is only available with TVs that support
progressive scan.
Progressive Scan Output (576p)
●
Consumers should note that not all high definition
television sets are fully compatible with this DVD
Recorder and may cause artifacts to be displayed in
the picture, in case of 576 progressive scan picture
problems, It is recommended that the user switch the
connection to the 'standard definition' output. If there
are questions regarding our TV set compatibility with
this model 576p DVD Recorder, please contact our
customer service centre.
19
English -