Antenna + HDD & DVD RECORDER +
External decoder box + TV
If you connect external decoder box to HDD & DVD
RECORDER, you can record scrambled channels
(CANAL+or Premiere broadcasts) received through
the built-in TV tuner in HDD & DVD RECORDER.
Wall
1
DECODER
2
1.
Connect RF antenna cables as shown.
2.
Connect the AV1 connector on this recorder to the
SCART AV connector on TV using a SCART cable.
3.
Connect the AV2 connector to a SCART AV
connector on decoder box.
4.
To watch or record PAY-TV Canal Plus
programmes, set your HDD & DVD RECORDER to
receive the channels using the on-screen display.
(Refer to pages 26~27)
3
4
English - 19
Other type of connecting the Video
output cable
There are several ways to output video signal not
using scart cables. Select one of the following
video connecting that best suits you below.
•
Case 1 : Connecting to a Video (Composite) output
jack
•
Case 2 : Connecting to an S-Video output jack
•
Case 3 : Component Video output jacks
S-Video, Component video and Progressive
Output Modes
•
S-Video and Component video output are available
only if your TV supports S-Video input or Component
video input, respectively. If S-Video or Component
video output does not work, check the TV
connections and the TV input selection settings.
•
Compared to standard interlaced video, progressive
scan doubles the amount of video lines fed to your
TV, resulting in a more stable, fl icker-free, clear
image than interlaced video. This is only available
with TVs that support progressive scan.
•
Progressive Scan Output (576P)
Consumers should note that not all high defi nition
television sets are fully compatible with this product
and may cause artifacts to be displayed in the
picture, in case of 576 progressive scan picture
problems, It is recommended that the user switch the
connection to the 'standard defi nition' output. If there
are questions regarding our TV set compatibility with
this model 576P HDD & DVD RECORDER, please
contact our customer service centre.