Wall Mount - Hach TU5300 sc Manuel D'utilisation Simplifié

Figure 3 Installation overview with no accessories
1 Service bracket
2 Process head
3 SC controller
4 Flow regulator

4.3 Wall mount

Install the instrument on a wall in a vertical position. Install the instrument so that it is level.
4.3.1 Install with the wall mount bracket
Refer to the illustrated steps that follow to install the instrument on a wall with the wall mount bracket.
The mounting hardware to install the wall mount bracket on a wall is supplied by the user.
If a 1720D, 1720E, or FT660 instrument is replaced, remove the instrument from the wall. Then do
steps 2 to 4 of the illustrated steps that follow to install the instrument on the existing hardware.
Note: When the accessories are used, the installation location of the tubing clips is different. Refer to the
documentation supplied with the accessories for tubing clip installation.
5 Sample inlet
6 Sample outlet
7 TU5300 sc or TU5400 sc
English 11