Publicité
Les langues disponibles
Les langues disponibles
Assembly
Unbox all parts
a. Cutter Base
b. Connecting Plate Assembly
c. Handle
d. Long Pin and Short Pin with C-clips (in place)
e. (1) 3/8" Cutting Plate (Pre-assembled)
f. (4) Large Suction Cup Feet (each has a Wing
Nut and Washer for attaching to Cutter Base)
Tools needed:
• Standard screwdriver (Not included)
• Needle-nose pliers (Not included)
1 Remove C-Clip from long pin located on the
back of the Pusher Block. Remove C-Clip from
short pin located on loose end of the Connect-
ing Plate.
2 Align the center-mounting hole of handle with
the mounting bracket holes located on the
EN
back of the Pusher Block. Insert Long pin and
secure with C-clip. (Use needle nose pliers to
place C-clip on pin then press until it snaps to
hold pin in place)
Wall Mounting (optional)
Before installation: check plate for any damage.
Be sure to inspect the wall-mount bracket for
any damage to make sure there are no dents im-
proper bends. Note: mounting screws and hard-
ware are not included
• Important: do not mount the bracket on drywall
or paneling without first anchoring to a wall
stud!
• Since significant force is required to pull down
on the cutter handle, the mounting bracket
must be securely anchored on a wall by at-
taching three of the vertical holes with 1/4"1ag
bolts to the center of an interior vertical wall
stud and the other three vertical holes to the
wall using 1/4" expanding toggle bolts. (sold
separately)
4
3 Align bottom hole of handle with holes in met-
al connecting plate, which is pre-attached to
the bottom of base. Insert Short pin and se-
cure with C-Clip (Use needle nose pliers to
place C-Clip on pin then press until it snaps to
hold pin in place)
4 Attach the front two feet through each slot at
the front of the base. Attach the back two feet
through the 2nd hole in from the edge at the
back of the base. Note: Pull the notch on the
top of each foot to release suction pressure af-
ter use. Note: Extra holes in the base can be
used for wall or counter mounting without the
feet.
5 Unit is ready to use.
• Locating wall studs: anchoring the mounting
plate on a wall stud assures that your fry cutter
will not pry loose during operation. Wall studs
are spaced either 16 or 24 inches on center
running floor to ceiling as part of a wood struc-
ture's framing. It is recommended to use an
electric stud finder (sold separately) to locate
wood (or steel) studs more quickly and accu-
rately for the location where you want to mount
the cutter wall bracket. Note: be aware that
items such as ducts, electrical wires and wa-
ter pipes may be behind the walls in your work
area. Exercise care when installing fasteners.
Publicité
