Broiler Flame; Operation; Operating Surface Burners - Amana ARG7800 Serie Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Adjust Oven Burner Flame
1. Remove storage drawer.
• See Removing Storage Drawer section.
2. Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
and air shutter.
3. Loosen air shutter lock screw and open or close air
shutter.
• If burner flame is blowing or noisy, reduce airflow to
burner.
• If burner flame is yellow and does not hold its
shape, increase airflow to burner.
• Tighten air shutter lock screw after adjusting.
4. Replace cover plate and storage drawer.
C
B
A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter
Adjusting Oven Burner Flame

Broiler Flame

Radiant Screen Style
Broiler flame should appear hazy or fuzzy. Haze should
3
be no more than
/
inch thick. The radiant screen should
8
begin to glow red or orange within 1–2 minutes.
Because broiler has a fixed orifice it can not be adjusted.
Broiler does not have an air shutter.
A

Operation

Operating Surface Burners

!
To avoid risk of serious personal injury, property
damage, or fire, do not leave burners unattended while
in operation. Grease and spillovers can ignite causing
a fire.
1. Push burner knob in and turn control knob
counterclockwise to LITE position.
• Burner should ignite within 4 seconds. If burner
does not ignite within 4 seconds turn control knob
to OFF position and follow directions in "Placing
Grates and Burner Caps" and "Before Calling for
Service" section. Try burner again. If burner still
does not ignite in 4 seconds, contact an authorized
servicer.
Burner Knob
2. After gas ignites, turn control to desired setting.
• Each control knob can be set to any required
cooking temperature. Burner settings do not have
distinct clicks.
• Use HI to bring food to boiling temperatures. When
food is boiling temperature setting should be
reduced.
• After lighting burner do not operate burner for long
periods of time without cookware on the grate. The
finish on the grate can chip without cookware to
absorb heat.
3. Turn control knob to OFF position when finished
cooking.
15
WARNING

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Arg7600 serie

Table des Matières