Turning On The Display Unit; Elementary Functions; Keypad Function Limitation; Deactivate "Limited" Mode - Tractel dynafor LLX1 Série Instructions D'emploi

6.1.4 Turning on the display unit

Sensor
Identification
Display unit
Master
GB
The welcome screen is shown for 4 seconds, then the standard display window is shown. When the radio
link is established between the sensor and the LLX1 display unit, the unit's symbol flashes on the sensor
screen and the force measured is simultaneously displayed on the two screens.

6.2 Elementary functions

This chapter presents the functions that enable elementary use of dynafor

6.2.1 Keypad function limitation

This function is used to limit access to the advanced functions of the display unit.
In "Limited" mode, only the three basic functions are accessible: UNITS, TARE, MAX.
In "Full access" mode, all the functions are accessible.
Transition from one mode to another is achieved by a sequence of buttons on the front panel of the
display unit.
This function facilitates use of the LLX1 System by the operator while eliminating the risk of an
inadequate operation due to certain parameters being changed.

6.2.1.1 Deactivate "Limited" mode:

Press the ESC key when the display unit is switched off.
The next time the display unit is powered up, the LLX1 icon will appear in the upper left corner of the
screen in place of the icon representing a key.

6.2.1.2 Activate "Limited" mode:

Press the ESC key when the display unit is switched off.
The next time the display unit is powered up, an icon representing a key will appear in the upper left
corner of the screen in place of the LLX1 icon.
ON / OFF (3 sec)
LIMITED mode
A
Current time
12
Radio
channel used
Current date
LLX1.
™
LLX1
FULL ACCESS mode