Program Switch - Cochlear Baha Cordelle II Mode D'emploi

English
On/Off and Volume control
Off When the volume control is in the 0 position it is off. You will feel a "click"
as it goes into off mode.
On For the sound processor to be on, the volume control must be set to a
position higher than 0. You will feel a click as the sound processor moves from off
mode to on mode.
Volume control If you turn the volume control towards the M/T switch the
volume increases, and if you turn it away from the M/T switch it will decrease.
Tone switch
The tone switch controls the frequency response. The switch can be set in three
different positions.
N = Normal. This gives the widest frequency response.
H = High frequency emphasis. This setting reduces low frequency sounds,
which often can improve speech understanding.
L = Low frequency emphasis. This position is often useful during the first period
after fitting as it allows you to gradually get used to high frequency sounds you
have not heard in a long time.
The tone switch is effective for all inputs (microphone, telecoil and
accessories connected via the direct audio input).
8
All manuals and user guides at all-guides.com

Program switch

The body worn unit is equipped with a program switch for the telecoil function.
The telecoil improves sound quality and speech understanding when using
telephones in homes where there are personal loop systems installed and in
other buildings with loop facilities.
There are three programs available. "M" is for listening with the microphone only.
In program "M/T" both the microphone and telecoil are active. In program "T"
only the telecoil is active.
Trim controls
There are two trim controls on the back of the body worn unit. These are to be
adjusted by audiologists only. When fitting the Cordelle, the audiologist will set
these trimmers to suit your needs.
English
9