Power Sources; Battery Power - Roadstar RCR-777UD+ Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
PRECAUTION
INSTRUCTIONS - All the safety and operating instructions should be read before
the radio is operated. The manual should be retained for future reference.
HEED WARNINGS - All warnings on the appliance and in the operating instruc-
tions should be adhered to.
WATER AND MOISTURE - The appliance should not be used near liquids or in
rooms with a high level of humidity.
VENTILATION - The appliance should be situated so that its location or position
does not interfere with its proper ventilation.
HEAT - The appliance should be situated away from heat sources such as radia-
tors, stoves or other appliances that produce heat.
POWER SOURCE - The radio should be connected to power supply only of the
type described in the operating instructions or as marked on the appliance.
POWER CORD PROTECTION -
are not likely to be walked on or pinched by items placed upon/against them.
OBJECT AND LIQUID ENTRY - Care should be taken so that objects do not fall
and liquids are not spilled into the enclosure through openings.
DAMAGE REQUIRING SERVICE
The appliance should be serviced by qualified service personnel when:
- The power supply cord or plug has been damaged;
- Objects have fallen into or liquids has been spilled into the radio;
- The appliance has been exposed to rain;
- The appliance has been dropped or the enclosure damaged;
- The appliance does not appear to operate normally.
SERVICING - The user should not attempt to service the appliance beyond that
descrive in the user operating instructions. All the servicing should be referred to
qualified service personnel
Note: If the display does not function properly or no reaction to operation of
any control may due to the electrostatic discharge. Switch off and disconnect the AC
cord and remove all the batteries, then turn the power back on after a few seconds.

POWER SOURCES

AC POWER: You can power your portable stereo system by plugging the AC po-
wer cord into the AC plug (19) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
Make sure that the AC power cord is fully inserted into the appliance.
BATTERY POWER: To use the radio with batteries, disconnect the AC power cord
and insert 6 × "LR14" batteries into the compartment (20).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your radio.
English
Power supply cords should be routed so that they
2

Publicité

Table des Matières
loading

Table des Matières