Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONNECTING TO POWER
Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other
power sources may damage the unit.
Caution
To prevent electric shock disconnect from the mains before removing cover. No user
serviceable parts inside. Refer servicing to qualified service personnel.
Safety Precaution
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: AC230Volts / 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not
required.
POWER SUPPLY
•
Remove the stereo carefully from the box, retaining the packaging for future use.
•
Please read this instruction book carefully before operating this unit.
AC Power Operation
•
Connect the AC Power Cord to your AC household mains outlet and switch ON.
•
Disconnect the power cord form the mains when not in use.
All manuals and user guides at all-guides.com
English
3
English
4
RADIO OPERATION
1.
Press the ON/OFF button (22).
2. Select the desired frequency band with the Function/Band Selector (12).
3. Tune to the desired radio station by turning the Tuning control (16).
4. Adjust the Volume control to the desired level.
5. To turn off the radio, press the ON/OFF - button (22).
Antenna
For FM reception there is a built-in FM antenna wire at the rear of the unit. Move the wire
around to obtain the best reception.
For MW reception the signals are picked up through a built-in ferrite antenna. Your may have
to orient the unit to obtain the best reception.
COMPACT DISC OPERATION
•
To remove a disc from its storage case, press down on the centre of the case and lift the
disc out, holding it carefully by the edges.
•
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a
soft cloth. Unlike conventional records, compact discs have no grooves to collect dust
and microscopic debris so gently wiping with a soft cloth should remove most particles.
Wipe in a straight line from the inside to the outside of the disc. Small dust particles and
light stains will have absolutely no effect on reproduction quality.
•
Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to
clean compact discs. These chemicals can irreparably damage the disc's surface.
•
Discs should be returned to their cases after use. This avoids serious scratches that
could cause the Laser pickup to skip.
•
Do not expose discs to direct sunlight, high humidity, or high temperatures for extended
periods. Long exposure to high temperatures can warp the disc.
•
Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
Publicité
Table des Matières
